By choosing an overhead door residential garage door you are doing more than making a home improvement investment you are making us a part of your daily life and relying on us for safety security and dependable operation.
10x8 garage door rough opening.
It s essential to get this measurement right else your newly purchased garage door won t fit the opening or might actually be smaller than the opening.
Cut the header from 2 x 12 lumber and to a length of the rough opening plus 6 inches.
A rough opening refers to the space left inside a door or window frame door in this case where the actual door will be fitted.
Therefore making the width of the garage door rough opening the same size as the door would be fine if you are going to use a thin layer of stucco vinyl siding or 1 by lumber.
In our business we refer to rough openings as the size of the opening before the finished lumber has been added to the jambs.
After installing the jambs your garage door opening should now be the same size as the garage door.
The rough opening is equal to the size of the door but you need to figure back head and side room before choosing and installing the new garage door.
On each side although some systems can require up to 5 1 2 in.
Words like rough opening are thrown around and i m not sure if we are speaking about the same thing.
Next you will need to know your door height.
How heavy garage door is.
1 2 or 1 in one direction of the other will won t typically cause you to have to shop for a non standard garage door size.
Most vertical track systems with torsion springs or other hardware require 3 3 4 in.
To make my.
Some garage door sizes usually wider or higher might be restricted from use in certain areas.
Overhead door residential garage doors.
Nail or screw 2 x 6 jambs to the framing on the top first and then the sides of the rough opening.
Step 1 measure the old door if you are replacing an existing door with one of the same size or the new door of choice if you are building a new garage.
Width of garage door opening standard widths are 8 9 10 12 14 16 17 and 18 height of the garage door opening standard residential heights are 7 7 6 8 header the header is ideally a minimum 12 wide micro laminated beam that spans the width of the garage door opening.
Ordering a garage door based on a rough opening size can leave you with a door that is too big.
However if you are putting bricks thick river rock stones marble or anything else on both sides that is more than 1 thick you will want the rough opening the same.
Standard garage doors in our area are 8 9 16 and 18 wide.
Install the header on top of the trimmers and nail.
The garage door is the gateway to your home.
The size of the door will be approximately the same as this sometimes called the rough opening next measure the sideroom or space available on the left and right sides of the opening.
Section 8 x 8 24 gauge steel door with tracks and all accessories might weight from couple to a few hundred pounds.